Looks in nice condition. 19kt. cruise on a 20,000# NB36 with 330hp sounds optimistic to me tho'.
What’s the spillover height of the water lift muffler vs. the spillover height of the exhaust riser shower head? The former should be much lower...
My boat has stainless and was built by someone who’s business was marine drivelines throughout NE. So I was surprised to read posts elsewhere that...
What was your problem w/ Brightside on deck?
Took this right around the corner from Friendship; the buoys ride right along the boot stripe both sides!
^Yep, as I said, spurs will cut without requiring tension which should be better. Back down into a line and you can still wind it up on the prop....
I like the fundamentals of this boat a lot; reputable hull design & construction coupled w/ a reputable engine. Appears to have very little...
I agree with Genius. Unless there's a toggle, no way I can snag a line while in forward motion; the keel pushes it out of the way just enough....
Blizten ran a rudder like the speed one and might have some advice. I’ve got the barn door w/ top & bottom gussets and have read numerous places...
Not the Mussel Ridge 48? or is that long wait time?
Droooool... Like a sexier Dixon.
Any slightly thickened epoxy (w/ fairing compound, milled fiber, etc.) or Hull ‘n Deck.
The 6CXM series is well-regarded, but rare so figured I would share this F/S posting I found; last listing at the bottom. No affiliation. Engines...
The only thing missing in that setup is a spare belt around the shaft & ziptied out of the way so you’re not screwed when the primary starts...
