looking sharp !!!!
the new to me 27 H&H has a belt driven pump, 3 gal. tank and 1.5 turn lock-lock helm pump.
Hydroslave, 1997 vintage, 2100 hrs on the 6BT 210....
are these plexi hinged windows still used? :eek:
the window on 27 H&H sedan is like looking through a keyhole.
On the list for an update.
fractions, percentages, math....all OK.
I keep it a bit more simple.
Total gallons of fuel burned for the boating season divided by the max fuel...
Interesting and thank you for the objective observation.
I plan to add a pr. onto the 27 H&H.
Only concern is the transom door.
I figure the units...
the new Extremist II is in the slip ![ATTACH]
what is the width of your tabs ?
and other than "auto"....how is the manual trim adjustment from side to side ?...bow down?
I'll need your expert opinion on where and what width ZIPS I should put on the back of the 27 H&H ? :)
What do you think?
I thought the Deere had a balance shaft ?didnt Tim mention vibration of the 4 banger compared to a 6 ?
seems you.d squeeze the two red tabs together and slide the pump off the bracket..No ?
Impeller is there
I use a Jabsco Water Puppy pump..12 volt with alligator clips ready to go. It's mounted on a small board. Intake hose is attached as is the...
and I was kidding about a gasser....Nice engine this Deere....but it's very difficult to get the vibration out of the 4 bangers. Cummins 4BT,...
too much...put a small block on the vdrive
better have a bite block in your mouth to keep your teeth from rattling. The little 4Bs shake and rattle a bit at idle ! :eek:
thank you the pictures !
Yes I installed a Centak 5" horizontal muffler in the 25 TJ with 6BTA 370 power.
The engine is propped to produce maybe 300 +- hp @ 3200 rpm....
even better without the muffler as far as any back pressure.
5" is good...will give you some margin for more hp in the future.:)
I have a 6BT 210 installed in the 27 H&H...it has a 5" exhaust diameter with a surge tube.
The 25 TJ has a 6BTA 370 intalled and has a 5"...
do have a picture of the ladder being used ?
where you installed the mounting tab ?